Iron Boots Configure Options
Use this guide to compare soles, stitching, heel profiles and toe patterns when ordering a pair of Iron Boots. Check your model’s order page for available options.
Hover over a photo to zoom. Select any photo to open it at full size.
Sole Options
Iron Boots X Dr Sole black rubber sole (up to size 10D)
It's our sole pattern OEMed by Dr Sole. Due to the limit size of the mould, it can only support up to 10-11D based on the model you ordered. If you ordered it with a size it won't fit, we will automatically switch it to the black Dr Sole 1220 Full rubber sole instead.
Stitching Options
Construction is how we join the upper to the sole. Our handwelted builds use a separate leather welt. The two handwelt options differ in how we finish the visible surface of that welt.
Stitchdown Construction
We turn the edge of the upper leather outward and stitch it down to the sole assembly. Look for the flared leather and the two visible rows of stitching in the photo.
Heel Options
Look at the back of the heel stack from the side. The logger heel curves inward toward the ground. The normal heel has a straighter profile with a slight taper, as shown on the Infantry.
Toe Options
The toe pattern changes the look of the front of the boot. Compare the leather and stitching across the toe in these examples.
Brogue Cap Toe
A separate leather cap with a row of decorative perforations along the seam. Shown on the Infantry.












